Label Material for Infusion & Medical Devices

FAQ

We keep getting edge lift on Infusion & Medical — what are the usual causes?

Three failures repeat on infusion bags and device housings: soft PVC bags plasticise and the plasticiser migrates into the adhesive; the label must stay legible after steam or EO sterilisation; a flexible surface lifts when the bag is hung full.

What should we put on the spec sheet for a Infusion & Medical label?

In this field the catalogue concentrates on Synthetic Paper, Copperplate Paper, Thermal Paper: 4 of the 4 constructions here use one of those faces, and Standard is the most frequent adhesive. That pairing is chosen for flexible PVC and sterilisation.

What certificates or documents come with Infusion & Medical material?

Each lot ships with a TDS for the construction and a lot number on the reel label. We also issue a written statement of the adhesive chemistry so your own REACH or FDA assessment can be completed. For food contact we can declare the face and adhesive only, not your printing ink.

Can you slit Infusion & Medical material to our core and width?

Jumbo roll or slit roll, wound to your core and width, in 500 ㎡ lots. We do not publish a single line-speed figure, because release force depends on your die, web tension and dwell. Send your m/min and we cut a trial roll to match.

Is there a smaller starting quantity for Infusion & Medical?

The catalogue MOQ is 500 ㎡ per construction; below that a coating run is not economic, so we quote a share of a scheduled run instead. Lead time is 15 days after artwork and roll-format approval, ex-works Guangzhou. It can be consolidated with other codes on the same shipment.

How long does approval take if we start with a Infusion & Medical sample?

Send substrate, line speed and roll format in the brief; we shortlist two or three constructions, then cut a trial roll for approval on your own press. Production starts only after you sign off that trial, and inspection happens before dispatch.