80μm PP Film Infusion & Medical Label Material — F80671

Construction

The three functional layers of this item. Selecting on face stock alone is where most specification errors begin — the adhesive and liner decide how it behaves on your press.

Product features

• Standard water-based adhesive with stable, consistent performance
• Synthetic paper face — water resistant, tear resistant, good stiffness

FAQ

Is Standard adhesive on F80671 (80μm PP Film) enough for infusion bags and device housings, or do we need higher tack, and how do we check that before a full run?

80μm PP Film is specified for the infusion & medical field, which does not mean every substrate in it. Synthetic paper prints like coated paper and survives water and tearing like a film. Where the surface is recycled or carries mould release, treat the first roll as a trial.

What is the minimum application temperature for F80671 (80μm PP Film, Standard) on a 62g White Glassine liner, and what happens at the low end?

No application-temperature figure is released for this construction, and we will not invent one. Adhesive wet-out decides the low end, and that depends on your line speed and the temperature of the bottle. The declared test condition is 23±2 °C / 50±5 % RH, and a trial roll shows where your own line sits.

What are the initial tack and 90° peel figures for F80671 (80μm PP Film, Standard), and which document states it?

No tack or peel figure is released for this construction, so we will not quote one. We report tack to FINAT FTM 9 by the ball method and 90° peel to FTM 2, at 23±2 °C / 50±5 % RH.

F80671 (80μm PP Film, Standard): what is the shortest lead time you can hold to, and at what quantity, and can it be pooled with other codes?

Minimum order quantity is 500 ㎡ and lead time is 15 days after artwork and roll-format approval. A trial roll for press approval can be arranged before the production run starts. Shipment is ex-works Guangzhou, and it can be consolidated with other codes on the same order.

Both look like the same face stock, so why pick F80671 (80μm PP Film) over F10050, and which one should we trial first?

F80671 runs Standard adhesive on 62g White Glassine Liner, while F10050 runs Low-odor / Residue-free on 36μm Clear PET Liner. The difference is the adhesive chemistry, which decides edge lift and high-speed behaviour more than the face does. Compare the two technical tables above, then test both on the same substrate.