75μm Synthetic Paper Digital Inkjet & Laser Label Material — F8582A

Construction

The three functional layers of this item. Selecting on face stock alone is where most specification errors begin — the adhesive and liner decide how it behaves on your press.

Product features

• Medium-tack adhesive system — balanced adhesion and converting performance
• Synthetic paper face — water resistant, tear resistant, good stiffness
• Verified by customer mass production

FAQ

F8582A (75μm Synthetic Paper): does the Medium-tack adhesive on 60g White Glassine give enough grab at the laser and inkjet printed sheets edge, and how do we check that before a full run?

75μm Synthetic Paper is specified for the digital inkjet & laser field, which does not mean every substrate in it. Synthetic paper prints like coated paper and survives water and tearing like a film. Not recommended for irregular or squeezable bottles.

Can F8582A (75μm Synthetic Paper, Medium-tack) be applied at 60 °C on the line, and what happens at the low end?

The minimum application temperature is 10 °C and the service range after labelling is -10–80 °C. Below the minimum the adhesive cannot wet out, and edges lift within hours on a curved wall. Both figures are measured at 23±2 °C / 50±5 % RH, so confirm them with a trial roll on your line.

Do the peel figures for F8582A (75μm Synthetic Paper, Medium-tack) change with the 60g White Glassine liner, and what substrate was it measured on?

Initial tack is ≥13 N by the ball method and 90° peel is ≥7 N/25 mm after 20 min. Both are measured to FINAT FTM 9 and FTM 2 at 23±2 °C / 50±5 % RH. Peel grows with dwell, so compare the same hold time against your own pull test.

How much F8582A (75μm Synthetic Paper, Medium-tack) on a 60g White Glassine liner do we have to order, and how long does it take, and can it be pooled with other codes?

Minimum order quantity is 500 ㎡ and lead time is 15 days after artwork and roll-format approval. A trial roll for press approval can be arranged before the production run starts. Shipment is ex-works Guangzhou, and it can be consolidated with other codes on the same order.

We used F10050 before. What changes if we switch to F8582A (75μm Synthetic Paper), and which one should we trial first?

F8582A runs Medium-tack adhesive on 60g White Glassine Liner, while F10050 runs Low-odor / Residue-free on 36μm Clear PET Liner. The difference is the adhesive chemistry, which decides edge lift and high-speed behaviour more than the face does. Compare the two technical tables above, then test both on the same substrate.